Midi music Mini SSTC type1 Instructions

Tiny SSTC Tesla Coil
4月 10, 2017
SSTC 260 intro
5月 24, 2017
Show all

Midi music Mini SSTC type1 Instructions

Midi SSTC Instruction

This article is about our products


this is a SSTC Project,it has two kind of Arc extinguishing model:

1.Fixed frequency mode
2.MIDI music mode

The full bridge GDT is wound with a EE25 transformer, with a drive of 4420 and a power tube of IGBT 50N60,support AC110-220v,so you can connect directly to the Home power jack(Equipment running will produce a lot of electromagnetic radiation, so please stay away from home appliances, and pay attention to safety)


In order to avoid traffic damage, you need to finish the best assembly
Don’t be afraid. It’s easy to install the secondary coil

there is a label on the wire,”L2″,”L2″ connect to another “L2”

Must cover with the tape!!!!!!!!

if not cove it,t may cause secondary coils to discharge and burn the machine!


And must must be grounded!!!!!!!!!!!

the device must connect to ground,the picture below show you how to grounding it

the black ground wire on the device is short,so you can use a long wire connect it to the metal stick in the ground,this is the best grounding.

if the real earth is too far ,or you are living in High  building,Toilet or kitchen metal pipes, or metal railings on the balcony are also available, but please make sure the connection is good


Connect arc extinguishing circuit board

There are two wire,one is for power,another is for the Arc extinguishing signal

Since the 2 interfaces look the same, don’t confuse them, so we’ll distinguish them in blue
The connection is blue to blue


another is the power wire,not show in the picture,you connect yourself


Function of arc extinguishing plate

Top potentiometer has two function

1.pulse width


when you receive the device,the swithc is close,so when you power on,there is no arc,you need turn it on(You’ll hear a crisp sound),Continue to rotate is to increase the pulse width


The bottom potentiometer

Frequency regulation

when you receive the device,The frequency is set to minimum,Rotation increases frequency,

But plz do not set the two potentiometer MAX at the same time(Operating at maximum power may result in overheating of equipment and burnout of equipment)

Pattern switch

when you receive the device,The switch is in the picture state,it is mode 1.Fixed frequency mode

this mode,you can turn the two potentiometer,and watch the ARC Changes in intensity and frequency

Change the mode must Power off!!!

you can not  Change-over switch directly when the power is on!!!

2.MIDI music mode

this mode need you input the MIDI Format music

(Only MIDI,do not input other format music ,like MP3,will broken device)



Here are some Midi format music for you

you can download

Midi (下载649)

2 评论

  1. Mark说道:


    Please help me to build my secondary and primary coil , how many turns ? what is aspect ratio ?



wp-puzzle.com logo